Power Distribution Board
- TSPS(R) distribution board case is manufactured by 0.8mm high-quality zinc-electrogalvanized steel plates, and is finished with flint grey epoxy powder; ABS transparent window is on the cover to facilitate inspection of components. Regards to access arrangements, both top and bottom entries are available.
- TSPS(R) distribution board is applicable with Schneider, ABB, Siemens, etc 18mm MCB. Special installation way is adopted among trail, components and cubicle. Therefore the trail and MCB are able to be unloaded together. This is convenient for users to connect the cable, and lower the cost as well by reduction in size.
- TSPS(R) distribution board is designed, manufactured and type-tested to under 50-60Hz 500V, loaded current not higher than 80A single or triple-phase power. The circuit breaker can be connected by comb-busbar manufactured by KEIYIP if required. Within the board there are neutral and earth terminals adequate for wiring.

TSPS(R) distribution board can operate normally when:
TPMS(R) distribution board
TPMS(R) distribution board is structured by 1.2mm high-quality zinc-electrogalvanized steel plates, and is finished with flint grey epoxy powder; ABS plastic arc frame and transparent cover is on the board to facilitate inspection of components. Regards to access arrangements, both top and bottom entries are available.

TSPS(R) distribution board
TSPS(R) distribution board case is manufactured by 0.8mm high-quality zinc-electrogalvanized steel plates, and is finished with flint grey epoxy powder; ABS transparent window is on the cover to facilitate inspection of components. Regards to access arrangements, both top and bottom entries are available.

Please leave us your messages and feedback, our sales engineers are always right beside you.